Brent Zollinger

1. Community
2. Feature Requests
3. Ability to Name Printers

Hi, the most recent firmware version for XiP and XiP Pro allow re-naming the printer from the System > About > Printer Information screen.

• Visualizza commento
• 29 agosto 2024 19:05
• 0 voti
• Commento ufficiale

1. Community
2. Feature Requests
3. surgical guide print isn't perfect

Hi, Please submit a support request to support@nexa3d.com and include the model printer, material brand, and a picture of the orientation and support settings you are using. You may need to alter t...

• Visualizza commento
• 30 luglio 2024 16:23
• 0 voti
• Commento ufficiale

1. Community
2. General Discussion
3. What causes unevenly adhesion to the build platform?

Build plate adhesion can become a complex topic very quickly. Primary factor is the first layer thickness. This depends on flatness of the build plate, flatness of the light engine, alignment of th...

• Visualizza commento
• 8 settembre 2023 00:40
• 0 voti

1. Community
2. General Discussion
3. What is the B-comp factor?

a/b compensation applies to sliced imaged, so yes - a compensation requires a closed interior contour. In your example the angled block slices on the top and bottom that don't fully enclose the ova...

• Visualizza commento
• 8 settembre 2023 00:25
• 0 voti

1. Community
2. General Discussion
3. What is the B-comp factor?

Negative a-compensation will remove material from inside edges like holes. It is in units of mm. If you have measured 9.85mm diameter hole and want to use a-compensation to correct it, then apply n...

• Visualizza commento
• 31 luglio 2023 19:32
• 0 voti
• Commento ufficiale

1. Community
2. General Discussion
3. What is the B-comp factor?

Cem, Thanks for your question. It comes up a few times so I will do my best to explain. First let me explain how compensation works. b compensation is an exterior edge offset in mm applied on the s...

• Visualizza commento
• 27 luglio 2023 14:54
• 0 voti

1. Community
2. General Discussion
3. General Questions

Hi. Let me try to answer your questions: Supports - we have 2 options Scaffold or Pillar type supports. With scaffold you cannot prevent it from building supports from the part, but you can adjust ...

• Visualizza commento
• 26 luglio 2023 01:52
• 0 voti
• Commento ufficiale

1. Community
2. General Discussion
3. Container / Waste Disposal

Aaron - Here is a link to my suggestions for handling waste. I'm open to hear other feedback or ideas on this topic. I know at least one person that has a UV wand attached to a cap they use to cure...

• Visualizza commento
• 27 aprile 2023 00:42
• 0 voti
• Commento ufficiale