Brent Zollinger
Commenti
Attività recente di Brent Zollinger
-
Hi, the most recent firmware version for XiP and XiP Pro allow re-naming the printer from the System > About > Printer Information screen.
- Visualizza commento
- 0 voti
- Commento ufficiale
-
Hi, Please submit a support request to support@nexa3d.com and include the model printer, material brand, and a picture of the orientation and support settings you are using. You may need to alter t...
- Visualizza commento
- 0 voti
- Commento ufficiale
-
Build plate adhesion can become a complex topic very quickly. Primary factor is the first layer thickness. This depends on flatness of the build plate, flatness of the light engine, alignment of th...
- Visualizza commento
- 0 voti
-
a/b compensation applies to sliced imaged, so yes - a compensation requires a closed interior contour. In your example the angled block slices on the top and bottom that don't fully enclose the ova...
- Visualizza commento
- 0 voti
-
Negative a-compensation will remove material from inside edges like holes. It is in units of mm. If you have measured 9.85mm diameter hole and want to use a-compensation to correct it, then apply n...
- Visualizza commento
- 0 voti
- Commento ufficiale
-
Cem, Thanks for your question. It comes up a few times so I will do my best to explain. First let me explain how compensation works. b compensation is an exterior edge offset in mm applied on the s...
- Visualizza commento
- 0 voti
-
Hi. Let me try to answer your questions: Supports - we have 2 options Scaffold or Pillar type supports. With scaffold you cannot prevent it from building supports from the part, but you can adjust ...
- Visualizza commento
- 0 voti
- Commento ufficiale
-
Aaron - Here is a link to my suggestions for handling waste. I'm open to hear other feedback or ideas on this topic. I know at least one person that has a UV wand attached to a cap they use to cure...
- Visualizza commento
- 0 voti
- Commento ufficiale